Register
 
DoubleCAD XT v5 has released

LTE version 5. Commands appear to have changed
Read 515 times
* March 14, 2016, 11:00:17 AM
 recently had trouble with Windows 10 and had to reset it. Following the reset I had to re-install TurboCAD LTE. Since then LTE appears to operate differently from previous.

I am having trouble with certain commands. One I appear to have lost completely is hatching. Using Trim it will trim the original line but not any lines which have been offset from the original line. The same happens with Extend. The original line will extend but lines which have been offset will not extend. These are the only discrepancies I have found so far, although I feel others may appear as I do more drawing.

How do I correct this?

The disc I re-installed LTE from was purchased in 2013 and although the disc has no version on it, the invoice stated LTE v5.

Logged


April 06, 2016, 05:08:25 AM
#1
Unfortunately LTE 5 was released way before win10. Therefore LTE 5t has never been tested on, nor is it supported on that OS.

Logged