Register
 
DoubleCAD XT v5 has released

Problem with Fit Radial Copy in Array command
Read 487 times
* January 31, 2016, 12:36:33 AM
Hello Brian, I have TurboCad Lte Pro^.0   32 Bit.
I am trying to draw a clock dial.  Following instructions very carefully in Array - Fit radial copy  and following instructions in Manual on P214,  the initial radial line  is copied 60 times as expected, but they are all tilted through about 30 degrees.  Have tried various options in the Inspector bar to no avail.  Any help would be much appreciated. John Davies

Logged


February 04, 2016, 06:49:24 AM
#1
Could you post a picture? Thanks

Logged


* February 04, 2016, 09:59:33 PM
#2
Try…

Sets: 61  60
Angle: 360  354
+Rot: 6

You'll end up with an extra line over the original; you can delete that.
« Last Edit: February 04, 2016, 10:06:41 PM by John R »

Logged
John R