Register
 
DoubleCAD XT v5 has released

Drawing lines
Read 171 times
* June 28, 2017, 05:28:39 AM
I don't know why but both version 3 and 8 on an XP computer that's not connected to the net stopped allowing me to draw lines by entering the draw to location. Clicking will work. If I draw 2 circles I can use snap and click that location such as center to center, center to quadrant. Yet nothing will work if something like @1.000,1.000 is entered. However all was working fine a bit ago. Tried shutting the computer down a few times and reload TurboCad LTE but with the same results. Any suggestion on what I can do?
« Last Edit: June 29, 2017, 06:09:15 PM by froneck »

Logged