DoubleCAD XT v5 has released

coordinate system
Read 1417 times
* April 19, 2014, 10:10:15 AM
I have a little problem with the interface. I want the coordinate system to read from the bottom left up, and right, instead of the center with positive and negative values. Let's say I draw a rectangle which will be the entirety of the drawing, with all other objects centered inside that rectangle. Having to position things from the center is a drag (on my mind). Any way to change that?

Also, when I draw a circle, I want to see where the center of the circle is. Anyway to put a spot there which stays even when unselected?

thanks for viewing


May 29, 2014, 07:58:32 AM
The coordinate system is an infinite plane. The Origin has no fixed location on your screen. Just pan until it is where you want it to be.