Register
 
DoubleCAD XT v5 has released

Join Polylines
Read 1464 times
* January 02, 2014, 06:40:19 AM
I'm sure it can be done, but I cannot figure it out.

Basically, I am drawing 4 lines to make a skewed rectangle, how can I join these lines so I can then apply a Brush to them?

I have read on this forum past solutions were they say to use the Join Polyline tool or Right Click and Select Finish but I do not see any of these options on DoubleCAD XT 5.0?

Thanks,

Mitch
« Last Edit: January 02, 2014, 06:43:51 AM by mitchelt »

Logged


January 06, 2014, 10:31:43 AM
#1
Join Polyline is a pro feature, but you can use chain polyline to accomplish the same ends

Logged


* January 07, 2014, 11:35:34 AM
#2
Perfect...that works!

Thank You

Logged