Register
 
DoubleCAD XT v5 has released

Thickness of polylines
Read 2243 times
* April 05, 2013, 06:20:40 AM
I am using TurboCAD LTE the 5.0 64 bit and wish to use polylines. I understand this should appear on the Inspector bar but in this case the Inspector bar does not show up anything for line thickness. How do I arrange for it to do so?

Logged


April 08, 2013, 07:21:51 AM
#1
Actually thickness cannot appear in the inspector bar or command line. Thickness is a Property rather than a geometric input.
The property toolbar at the top of the screen is where you input the line thickness (or in the property dialog/selection info palette)

Logged


* April 24, 2013, 07:16:36 AM
#2
Thanks theBrian. Using the properties line at the top of the page appears only to give a constant line thickness. How can you change the width from one end of the line to the other. According to your online user guide a dialogue box should appear in which you insert the start and end widths. However this does not appear on my drawings. I am using TurboCAD LTE 5.0 64-bit.
Mac.

Logged


April 25, 2013, 09:21:04 AM
#3
To make that box appear:
Select the Polyline tool
Then Right-Click
finally select Polyline Properties

You can do this at each vertex of the polyline.

Logged