Register
 
DoubleCAD XT v5 has released

Recent Posts

Pages: 1 ... 8 9 [10]
91
Need Help? Problems - Solutions / Problem with Fit Radial Copy in Array command
« Last post by John Davies on January 31, 2016, 12:36:33 AM »
Hello Brian, I have TurboCad Lte Pro^.0   32 Bit.
I am trying to draw a clock dial.  Following instructions very carefully in Array - Fit radial copy  and following instructions in Manual on P214,  the initial radial line  is copied 60 times as expected, but they are all tilted through about 30 degrees.  Have tried various options in the Inspector bar to no avail.  Any help would be much appreciated. John Davies
92
Need Help? Problems - Solutions / Re: Count Block Insertions
« Last post by Richard64 on January 29, 2016, 12:12:53 PM »
Thanks John.
93
Need Help? Problems - Solutions / Re: Count Block Insertions
« Last post by John R on January 28, 2016, 11:49:45 PM »
If you have a LTE Pro version, you can use "Edit / Select By / Query…". In 'non-Pro' versions, you can try "Edit / Select By / Entity Type…", but it shows "all" Blocks.
94
Need Help? Problems - Solutions / Count Block Insertions
« Last post by Richard64 on January 28, 2016, 03:41:52 AM »
Is there any way to count the number of specific blocks inserted into each drawing?
Thanks
95
TurboCAD LTE Discussion / Re: File Filter
« Last post by Steve The Kiwi on January 03, 2016, 09:40:08 AM »
Greg, I have PM'd you.
96
TurboCAD LTE Discussion / Re: File Filter
« Last post by gcardinal on January 03, 2016, 09:05:54 AM »
Greg, try running the program in compatibility mode. Right click the program icon and select Compatibility, in Compatibility mode, select Win XP an then select OK. Then try again.

Steve, compatibility mode doesn't give me a Win XP option. Only Win 7, 8 and Vista.  XP is the system I used previously when it worked.

Thanks,

Greg
97
TurboCAD LTE Discussion / Re: File Filter
« Last post by gcardinal on January 03, 2016, 08:59:33 AM »
gcardinal,

under Help-->About TurboCAD what build number does it say that you have?

Travman, I am using build number 9.5
98
DoubleCAD XT Discussion / Re: Where can I find DoubleCad XT V3?
« Last post by Steve The Kiwi on December 28, 2015, 08:17:12 AM »
You may find it after some good searching, all I can find is V5. What about in your downloads folder of your old pc?
99
TurboCAD LTE Discussion / Re: File Filter
« Last post by Steve The Kiwi on December 28, 2015, 08:11:43 AM »
Greg, try running the program in compatibility mode. Right click the program icon and select Compatibility, in Compatibility mode, select Win XP an then select OK. Then try again.
100
TurboCAD LTE Discussion / Re: File Filter
« Last post by Travman on December 15, 2015, 07:46:33 AM »
gcardinal,

under Help-->About TurboCAD what build number does it say that you have?
Pages: 1 ... 8 9 [10]